Glock Maintenance Tips

0
200

A lot of folks I talk to dont seem to know some of the simple, yet important points about how their Glocks work and how to anticipate or troubleshoot problems. I see a lot of them in classes, and Glock is claiming a 70+ percent share of the law enforcement market these days. With that in mind, here are a few things that might help you keep them running likewell, Glocks. Im going to assume you can field-strip your gun correctly, so Im not going into that specifically. And Im not going to go into any further disassembly other than basic field stripping. If you discover by doing these checks that you have a potential problem, get the gun to your local Glock armorer.

2Whats that for?


While you have the slide in your hand, remove the recoil spring assembly and the barrel and hold the slide so it is muzzle end down and the bottom facing you. See the hole just the above the breech face? Thats not a lubrication hole. It leads into the firing pin channel and is there to allow any debris in the channel to work its way out. If you put oil in there, it will literally gum up the works, as it holds in the stuff that would normally find its own way out. The firing pin assembly moves in its channel, inside a polymer liner. That provides all the lubrication needed. Make sure the firing pin is in its rearward position (sometimes it is protruding through the breech face when you take the gun apart). If you hold the slide vertically and push in on the firing pin safety (the round, spring loaded button), the firing pin should drop freely from its own weight into the fired position. If not, try holding the button in and move the firing pin gently up and down with your finger. If it is binding at all, the firing pin channel needs cleaning. (Thats an armorers job.) By the way, never push the firing pin to the rear against its own spring tension and allow it to snap forward. This can damage the firing pin safety, causing it to fail.

Another way to help keep junk out of the firing pin channel is to make sure you hold the slide muzzle down when you are cleaning the breech face and the extractor. If you hold it muzzle up (so its easier to see what you are doing), dirt, solvents and lubricants can get into the channel through the hole in the breech face. Again, this is to be avoided. One last point on the slide operation: check to be sure the extractor isnt damaged. Look at it from the bottom, because it can look normal from the top, but the bottom edge, where most of the wear happens, can be chipped.

LEAVE A REPLY

Please enter your comment!
Please enter your name here